Stihl MS 441 Manual page 127

: Clip one of the two test lines onto
the heating element and the
other onto the round connector.
If the heating element is in good
condition, the ohmmeter will
indicate about 8 ohm in the
measuring range "Ω".
– Check correct operation,
b 15.2.
1
: Slide heating element (1) onto
the carburetor.
126
1
– Push connector and terminal
socket (arrow) together as far as
possible.
: Slide insulating tube (1) over the
plug connection.
1
The insulating tube must cover the
plug connection completely – risk of
short circuiting.
: Press plug connection (1) into the
guides (arrows).
Ensure that wires are not crossed.
– Install filter base, b 14.1.2.
1 2
: Attach wiring (1) to mount (2) and
press it into the cable guides
(arrows).
The wiring must not touch either the
carburetor levers or the spacer
flange.
Thermostatic switch
: Pull connector (arrow) off
terminal socket.
– Remove carburetor, b 14.3.
MS 441, MS 441 C