General Notes; On-Board Tool Kit - BMW S 1000RR Rider's Manual

General notes

10
The Maintenance chapter de-
scribes work involving the check-
168
ing and replacement of wear
parts that can be performed with
a minimum of effort.
If special tightening torques are
to be taken into account for
assembly, these are listed. An
overview of all required tightening
torques is contained in the
Technical Data chapter.
Information on additional main-
z
tenance and repair work is pro-
vided in the Repair Manual for
your motorcycle on DVD, which
you can obtain from your autho-
rized BMW Motorrad retailer.
Special tools and thorough spe-
cialized knowledge are required
to carry out some of the work
described here. If you are in
doubt, consult an authorized
workshop, preferably your au-
thorized BMW Motorrad retailer.

On-board tool kit

1 Lever
without Dynamic Damp-
ing Control (DDC)
Adjusting spring preload
at rear wheel (
with Race package
or
with M package
Adjusting the ride height
at the traction strut
( 107).
2 Open-ended wrench
Wrench size: 10/13
Removing battery
( 196).
2 Adjusting the spring
preload on the front
wheel (
with Dynamic Damping
Control (DDC)
Adjusting spring preload
at rear wheel (
3 Reversible screwdriver in-
sert
Slotted blade and T25 torx
Remove and install trim
panel components.
Remove rider's seat
OE
(
without Dynamic Damp-
101).
ing Control (DDC)
OE
Adjusting the compres-
sion damping on the
OE
front wheel (
without Dynamic Damp-
ing Control (DDC)
Adjusting the rebound-
stage damping on front
wheel (
100).
OE
102).
73).
OE
104).
OE
104).