General Notes; Rear-Wheel Stand - BMW HP4 RACE Rider's Manual

General notes

9
The 'Maintenance' chapter de-
scribes work involving the check-
106
ing and replacement of wear
parts that can be performed with
a minimum of effort.
If special tightening torques are
to be taken into account for
assembly, these are listed. An
overview of all required tightening
torques is contained in the
chapter "Technical Data".
z
Special tools and thorough spe-
cialized knowledge are required
to carry out some of the work
described here. If you are in
doubt, consult an authorized
workshop, preferably your au-
thorized BMW Motorrad retailer.

Rear-wheel stand

Mounting the rear-wheel
stand
Hold the motorcycle straight
and attach the rear-wheel
stand 1 to the stand mounts 2.
ATTENTION
Motorcycle tips to side
Component damage cause by
tipping over
Secure motorcycle against tip-
ping away to side.
Press down the rear-wheel
stand 1 until the motorcycle
is vertical and the handle for
the rear-wheel stand 1 is on
the floor.
Removing the rear-wheel
stand
Secure the motorcycle against
falling over and slowly lower
the rear-wheel stand 1, take
away the rear-wheel stand 1.