BMW S 1000RR Rider's Manual page 187

screws 1 with the appropri-
ate torque.
Radial brake caliper in
axle mount
28 lb/ft (38 Nm)
Remove adhesive tape from
wheel rim.
Operate brake lever firmly sev-
eral times until the pressure
point can be felt.
Remove front wheel stand and
auxiliary stand.
Removing rear wheel
Raise motorcycle, preferably
with a BMW Motorrad rear-
wheel stand.
Mounting the rear-wheel stand
( 170).
Support the rear wheel, e.g.,
with a wooden block, so that
it cannot fall down after the
quick-release axle is removed.
Press the brake caliper 1
against the brake disk 2.
Brake pistons are pressed
back.
Remove the axle nut 1 with
washer.
Loosen the lock nuts 2 on the
left and right.
Loosen the adjustment
screws 3 on the left and right.
Remove adjustment plate 4
and slide axle as far as possible
inside.
Remove the quick-release
axle 2 and take out the adjust-
ment plate 1.
10
185
z