BMW S 1000RR Rider's Manual page 53

Possible cause:
The Hill Start Control (
was activated by the rider.
Switch off Hill Start Control.
Using Hill Start Control (
Hill Start Control is
automatically deactivated
Yellow stop symbol flashes.
Possible cause:
Hill Start Control was deactivated
automatically.
Side stand was folded out.
Hill Start Control is deactivated
when the side stand is folded
out.
Engine was stopped.
Hill Start Control is deactivated
when the engine is stopped.
Using Hill Start Control (
Hill Start Control cannot
be activated
165)
Crossed-out stop symbol is
displayed.
66).
Possible cause:
The Hill Start Control can not be
activated.
Fold in side stand.
Hill Start Control only functions
when the side stand is folded
in.
Start engine.
Hill Start Control only functions
with the engine running.
Gear not trained
The gear indicator flashes.
The gearshift assistant Pro
has no function.
Possible cause:
66).
The transmission sensor has not
been completely trained.
Engage idle position N and al-
low the engine to run for at
least 10 seconds while parked
to train the idle position.
Shift all gears with clutch con-
trol and drive for at least 10
seconds in each engaged gear.
The gear indicator stops flash-
ing when the transmission
sensor has been successfully
trained.
Once the transmission sensor
is fully trained, the Gear Shift
Assistant Pro functions as de-
scribed ( 164).
If the training procedure is
unsuccessful, have the fault
corrected at a specialist work-
shop, preferably an authorized
BMW Motorrad retailer.
Hazard warning lights
system switched on
Left turn signal indicator
light flashes green.
3
51
z