Chapter 7
7.3.2
WinX/32 Step-by-Step Procedure
The following procedure uses a ProEM:1600
used to increase the spectral readout rate for a ProEM:1600
1.
On the Experiment Setup
•
•
2. On the Hardware Setup
•
3. Select Easy Bin from the Acquisition menu.
•
See
Figure 7-2:
4. Acquire a spectrum.
NOTE:
The Readout Times you get may differ from those reported
in this procedure. These values are intended to show the
effect of the changes on Readout Time reduction.
►
Rate: 4 MHz
Readout Port: Multiplication Gain
►
Controller/Camera tab, select:
Vertical Shift = 2
s
Select ALL. This will result in Full Vertical Binning.
Figure
7-2.
Typical WinX/32 Easy Bin Dialog
Tips
(2)
camera. This same procedure can be
ADC tab, select:
(4)
.
117