Lightfield; Figure 4-11: Typical Lightfield Experiment Workspace - Teledyne ProEM Series System Manual

Chapter 4
4.9.2

LightField

1. Make sure the ProEM (and spectrograph, if this is a spectroscopy system) is
connected to the host computer and that the camera (and spectrograph) power
supply is turned on.
2. Start LightField.
3. While LightField is starting up, it will detect the available device(s) and load the
appropriate icons into the Available Devices area in the Experiment workspace.
4. When you drag an icon into the Experiment Devices area, the appropriate
expanders will be loaded into the Experiment Settings stack on the lefthand side of
the window.

Figure 4-11: Typical LightField Experiment Workspace

5. Because this is a new experiment, the default settings will automatically be entered
for the experiment device(s). These settings will allow you to begin previewing (Run
button) or acquiring (Acquire button) data.
System Setup
NOTE:
For a step-by-step procedure on basic system operation
(Imaging and Spectroscopy), refer to the appropriate First
Light sections:
• Section 5.2.1, Imaging
• Section 5.2.2, Spectroscopy
Applications, on page 61;
Applications, on page 65.
49