Lightfield To Winspec/32; Table D-2: Lightfield-To-Winspec/32 Cross Reference - Teledyne ProEM Series System Manual

Appendix D
D.2

LightField to WinSpec/32

Refer to
terms.
Table D-2: LightField-to-WinSpec/32 Cross Reference (Sheet 1 of 2)
Active Area: Bottom Margin
Active Area: Left Margin
Active Area: Right Margin
Active Area: Top Margin
Active Area: Top Margin
Active Height
Active Width
Always Closed (Shutter)
Always Open (Shutter)
Analog Gain
Bit Depth
Clean Cycle Height
Clean Serial Register
Clean Until Trigger
Closing Delay
Custom Sensor
Custom Timing
Final Section Count
Final Section Height
No Response
Normal (Shutter)
Number of Clean Cycles
Open Before Trigger (Shutter)
Opening Delay
Output Signal
Output Signal: Always High
Output Signal: Always Low
Output Signal: Busy
Output Signal: Not Reading Out
Output Signal: Shutter Open
WinSpec/32/LightField Cross Reference
Table D-2 for a list of LightField terms and their corresponding WinSpec/32
LightField Term WinSpec/32 Term
Post-Dummy Rows Parallel to Shift Register
Pre-Dummy Shift Register Columns
Post-Dummy Shift Register Columns
F.T. Dummies or Frame Transfer Dummies
Pre-Dummy Rows Parallel to Shift Register
Active Rows Parallel to Shift Register
Active Shift Register Columns
Disabled Closed (Shutter)
Disabled Open (Shutter)
Controller Gain
ADC Resolution
Number of Strips per Clean
Skip Serial Register Clean (deselected)
Continuous Cleans
Shutter Close Compensation Time
Custom Chip
Custom Timing
Number of Blocks
Minimum Block Size
Free Run
Normal Shutter
Number of Cleans
PreOpen (Shutter)
Shutter Open Compensation Time
Logic Out
Logic Out: Logic 1
Logic Out: Logic 0
Logic Out: Not Ready
Logic Out: Not Scan
Logic Out: Shutter
155