Connectors; Figure 2-4: Proem Connectors And Indicators; Table 2-1: Proem Connectors And Indicators - Teledyne ProEM Series System Manual

22
2.2.5

Connectors

Figure 2-4
camera.

Figure 2-4: ProEM Connectors and Indicators

Refer to
Table 2-1:
Connector
Gig-E
Shutter
Power
Ext Sync
ProEM System Manual
shows the connectors and indicators found on the rear of the ProEM
SHUTTER
GIG-E
Table 2-1 for information about each connector and indicator on the camera.
ProEM Connectors and Indicators (Sheet 1 of 2)
Gigabit Ethernet connector. Used with the Cat 5e/6 Gigabit Ethernet cable
(supplied) interconnecting the camera and the GigE interface card in the host
computer. A high quality cable must be used to preserve data integrity during
transmission. The cable can extend the distance between camera and the host
computer by more than 50 m.
®
LEMO connector provides the shutter drive pulses for driving a Teledyne
Princeton Instruments-supplied 25 mm external shutter. Camera power must be
off before connecting to or disconnecting from this connector.
NOTE: When there is an installed internal shutter, this connector cannot drive
an external shutter.
24 V (5.3 A max) input and TEC control from power supply.
DC
0 to +3.3 V logic level input (TTL-compatible) that has a 10 k
Allows data acquisition and readout to be synchronized with external events.
Through software, positive or negative (default) edge triggering can be selected.
EXT SYNC
POWER
LOGIC OUT
Description
Issue 3

pull-up resistor.