Checking The Equipment And Parts Inventory; System Requirements; Environmental Requirements; Ventilation - Teledyne ProEM Series System Manual

36
4.2

Checking the Equipment and Parts Inventory

Confirm that you have all of the equipment and parts required to set up the ProEM
system. A complete system consists of:
•
•
•
•
•
•
•
•
•
4.3

System Requirements

4.3.1

Environmental Requirements

4.3.2

Ventilation

•
ProEM System Manual
Camera
Power Supply
Host Computer: Can be purchased from Teledyne Princeton Instruments or
provided by user. For enhanced performance, a fast hard drive (10,000 rpm) and
2GB RAM is recommended.
Operating System:
— WinView/32 or WinSpec/32: Windows
(32-bit)
— LightField: Windows Vista (64-bit) or Windows 7 (64-bit)
Computer Interface Components:
— Ethernet Cable: 15 ft (5 meter) cable (6050-0621) is standard.
— GigE Interface Card (provided with the ProEM system)
External Sync and Logic Out Cables: MCX-to-BNC adapter cables.
Hoses: Two coolant hoses with ProEM-compatible quick-disconnects.
Application Software:
— WinView/32 or WinSpec32 (Ver. 2.5.25 or later) CD-ROM (optional)
— LightField CD-ROM (optional)
Software User Manual (provided with application software)
≤
Storage temperature:
Operating environment temperature: +5°C to +30°C; the environment
temperature at which system specifications can be guaranteed is +20°C
≤
Relative humidity 50%; non-condensing
NOTE:
For TE-cooled cameras, the cooling performance may
degrade if the room temperature is above +20°C.
Camera
Allow at least two (2) inches [50 mm] clearance around the vented covers. The
air needs to be less than 25°C (above this temperature the CCD temperature
can begin to degrade). Where the camera is inside an enclosure, the enclosure
needs to have unrestricted flow to an open environment. The camera vents its
heat out the vents near the nose. The air intake is near the rear of the camera.
®
XP (32-bit, SP3 or later) or Vista
55°C
Issue 3
®