Figure A-1: Rear Of Proem Camera; Table A-3: Power Connector Pinout - Teledyne ProEM Series System Manual

Appendix A
•
•
•
•
•
•
•
•

Figure A-1: Rear of ProEM Camera

Technical Specifications
Temperature Stability: ±0.05°C; closed-loop stabilized-temperature control
Gain: Software-selectable [1 (low), 2 (medium), 3 (high)]
Dimensions: Refer to Appendix B, Outline
Connectors:
— Gig-E: Gigabit Ethernet connector.
®
— Shutter: LEMO connector provides the shutter drive pulses for driving a
Teledyne Princeton Instruments-supplied 25 mm external shutter in lieu of
integrated shutter. Camera power must be OFF before connecting to or
disconnecting from this connector. Cable not supplied.
When there is an installed internal shutter, this connector cannot drive an
external shutter.
Ext Sync: 0 to +3.3 V logic level input to allow data acquisition to be
synchronized with external events. Trigger edge can be positive- or
negative-going as set in software. Synchronization and Timing Modes are
discussed in Chapter 6, Advanced
supplied with system.
Logic Out: 0 to +3.3 V programmable logic level output (TTL-compatible). The
output of this connector can be programmed and can also be inverted via the
application software. For detailed information about each output signal, refer to
Section 6.3, LOGIC OUT
Power Connector:
Figure A-1 shows the Power Connector on the rear panel of the ProEM camera,
including the pinout diagram. Refer to
pin assignment information.
5 4 3
A2 A1
2 1
Table A-3: Power Connector Pinout (Sheet 1 of 2)
Pin #
A1 TEC Return
Drawings, on page 141
Topics. MCX-to-BNC adapter cable is
Control, on page 97.
Table A-3, Power Connector
Signal
139
Pinout, for