Hoses; Table 2-3: Standard Proem Camera System Hoses - Teledyne ProEM Series System Manual

24
Table 2-2: Standard ProEM Camera System Cables (Sheet 2 of 2)
Cable
MCX to BNC
Power Cable
2.5

Hoses

Table 2-2
System.

Table 2-3: Standard ProEM Camera System Hoses

Coolant Hoses
ProEM System Manual
Part
Number
6050-0540
6050-0596
provides information about hoses included with a standard ProEM Camera
Hose
Two 10 mm [3/8-inch] ID hoses are supplied with every ProEM
system. Quick-disconnects that mate to the ProEM's coolant
ports have been installed on one end of each hose.
Refer to the coolant circulator's specifications regarding
circulator-compatible hose fittings.
If a Teledyne Princeton Instruments CoolCUBE
ordered with the camera, hoses are supplied with appropriate
connectors on both ends.
Description/Purpose
Two MCX to BNC adapter cables are provided
with the ProEM system. These connect to the EXT
SYNC and the LOGIC OUT connectors on the
rear of the ProEM..
The power cable connects the ProEM camera to
its power supply..
Description/Purpose
Issue 3
Length
Varies
3 m
[9.8 ft]
Length
3 m
[9.8 ft]
circulator is
II