Figure 4-6: Coolcube Ii With Reservoir Cap Removed - Teledyne ProEM Series System Manual

44
Figure 4-6: CoolCUBE
If additional coolant is required, fill with a 50:50 mixture of water and ethylene
glycol.
6. Screw the reservoir cap back in.
7. Plug the circulator into a 100-240 V
8. Turn the circulator on. Make sure there are no leaks or air bubbles in the hoses.
a. If there are no problems, proceed to step 9.
b. If there are leaks or air bubbles, turn the circulator off and correct the
9. Turn the camera on.
10. Start the application software.
ProEM System Manual
with Reservoir Cap Removed
II
problem(s) by securing the hoses or adding more coolant to the reservoir. Turn
the circulator back on. Recheck and if there are no problems, proceed to step 9.
, 50-60 Hz power source.
AC
Issue 3