Chapter 5
Setting the Parameters
Set the software parameters as follows:
•
Figure 5-2: Typical WinX/32 Controller/Camera Tab
Operation
NOTE:
The following procedure is based on WinView/32: you will
need to modify it if you are using a different application.
Basic familiarity with the WinView/32 software is assumed. If
this is not the case, you may want to review the software
manual or have it available while performing this procedure.
Controller/Camera tab (Setup
These parameters should be set automatically to the proper values for your
system.
— Controller type: This information is read from the camera.
— Camera type: This information is read from the camera.
— Shutter type: Custom (System dependent).
— Readout mode: Available modes are read from the camera. Select Frame
Transfer.
See
Figure
5-2.
►
Hardware)
S
ELECT
53
F
T
RAME
RANSFER