Coolant Ports; Coolant Circulator; Cables; Table 2-2: Standard Proem Camera System Cables - Teledyne ProEM Series System Manual

Chapter 2
Table 2-1:
Connector
LOGIC OUT
2.2.5.1

Coolant Ports

QDC (Low Profile) Male Shutoff Nozzles (Koolance, part number VL2-MG). Located on
the side of the camera, these are interchangeable quick-disconnect inlet/outlet ports.
ProEM-compatible female barbs (part number VL2-F10B-P) are available from Koolance
(www.koolance.com).
2.3

Coolant Circulator

ProEM cameras can be optionally cooled by circulating coolant to provide a low
vibration system for data acquisition. They are equipped with two ports with
quick-disconnect fittings for connection to an external circulator. Two 10 mm
[3/8 inch] ID, 3 meter [10 foot] coolant hoses with ProEM-compatible fittings are
provided with each ProEM system.
The coolant circulator can be any commercially available circulator that is capable of
continuously pumping a 50:50 mixture of room temperature (23°C) water and ethylene
glycol at 1 liter per minute, or the Teledyne Princeton Instruments CoolCUBE
the factory for recommendations. Refer to
complete information.
2.4

Cables

Table 2-2
Table 2-2: Standard ProEM Camera System Cables (Sheet 1 of 2)
Cable
Ethernet
Cable
ProEM Camera System
ProEM Connectors and Indicators (Sheet 2 of 2)
0 to +3.3V programmable logic level output (TTL-compatible). The output of
this connector can be programmed and can also be inverted via the application
software. Refer to Section 6.3, LOGIC OUT
information about each LOGIC OUT signal.
describes the cables included with a standard ProEM Camera System.
Part
Number
6050-0621 This standard cable is a Cat 5e/6 Ethernet cable
for connecting the camera and the host
computer. The distance between the camera and
the computer can be over 50 meters. Contact the
factory for longer cables.
Description
Control, on page 97 for complete
Contact Information on page 160 for
Description/Purpose
23
. Contact
II
Length
5 m
[16.4 ft]