Figure 5-10: Typical Lightfield View Area - Teledyne ProEM Series System Manual

Chapter 5
3. Note that the Experiment Settings stack on the left now displays several expanders.
Because this is a new experiment, the default settings for the camera will be active.
The Status bar (at the bottom of the window) displays icons for temperature status
and orientation.
•
•
Acquiring Data
1. Click on the View tab, just above Experiment Devices, to change to the display area.
See

Figure 5-10: Typical LightField View Area

2. Click on the Run (Infinite) button
images will be continuously acquired and displayed. See
Operation
Temperature status reports the current temperature and whether the set
temperature has been reached. Clicking on the icon, opens the Sensor
expander which is where the set temperature can be changed.
Orientation is displayed because the default readout port is Electron Multiplied.
Clicking on the icon pops a panel that describes how the image orientation was
corrected.
Figure 5-10.
to start Preview mode. In this mode,
Figure 5-11.
63