Ricoh Provence-P2W User Manual page 81

Reducing and Enlarging by a Specified Ratio (Scale, Directional magnification)
Contents Previous
Printing > Various Print Functions
Reducing and Enlarging by a Specified Ratio (Scale, Directional magnification)
Follow the procedure below to print with a reduction or enlargement ratio in the range of 20-300% adjustable in 1%
increments. Use this to reduce the size of the print image slightly to insert a margin, for example.
Two methods are available: scale and directional magnification. Scale is used to specify the same ratio in both
horizontal and vertical directions while directional magnification is used to specify a different ratio for each direction.
Open the file you want to print from the application, and then open the printer properties dialog box.
Click the [Page Settings] tab.
Select the [Reduce/Enlarge] check box, and then click [Scale] or [Directional magnification...] in the list.
If [Scale] is selected, enter a ratio in the [Scaling(%):] box.
Enter a number between 20 and 300.
In the [Printout paper size:] list, you can change the paper size.
If [Directional magnification...] is selected, enter ratios in the [Vertical:] and [Horizontal:] boxes, and
then click [OK].
Select the [Centering] check box to center an image.
If [Scale] or [Directional magnification...] is selected, a wide margin may be created on the right or bottom of the paper. If this happens,
select the [Centering] check box to center an image and create margins of the same width.
If the [Centering] check box is not selected, the reduced or enlarged image is positioned in the upper left of the paper.
Make the necessary settings, and then click [OK].
The printer properties dialog box closes.
Make print settings, and then click [OK].
Opening from an Application
Top
Copyright © 2005 All rights reserved.
file:///E|/shared/pdf-work/newfiles/pp2w/Op_Guide/int/0041.htm (1 of 2)2005/10/05 12:03:31
Next
> Reducing and Enlarging by a Specified Ratio (Scale, Directional magnification)
Previous Next
Settings