Broadcast Datalink Setup; Figure 22: System Info-Datalink Info Page For Orbcomm - Avidyne Entegra EX5000 MFD Series Installation Manual

ORBCOMM Datalink Checkout
➤
To check the ORBCOMM Datalink installation:
1. From the Maintenance Mode page, select System Info. The System Info page displays:
2. In the Page dropdown, select Datalink Info.
3. On the Datalink Info page, verify the SC Serial Number and software versions.
If ORBCOMM is enabled and the port is selected on the Aircraft Setup page, the EX500 is
configured for ORBCOMM operation.
➥
To finish the checkout process, see Section 6.5, "2-Way Datalink Satellite Reception Confirmation"
on page 85.

5.11.3 Broadcast Datalink Setup

On some aircraft, the MFD supports the Heads Up XMD076 XM data receiver or Avidyne MLB700
Sirius broadcast receiver. If XM or WSI is available and an XM or WSI receiver has been installed on
this aircraft, the Broadcast pull-down will be available.
Configure Broadcast as follows:
● Broadcast—XM Radio or Sirius Radio. This enables the Datalink functionality and communication
with the satellite data receiver.
●
Port—Select the RS-232 port wired to the broadcast receiver.
Figure 22: System Info—Datalink Info Page for ORBCOMM
- 76 -
EX5000 Installation Manual
P/N 600-00073 Rev 24