Traffic Communications Check (Messages); Table 22: Traffic Messages - Avidyne Entegra EX5000 MFD Series Installation Manual

5.7.9 Traffic Communications Check (Messages)

After the MFD has been restarted, any of the following messages may appear in the main viewing
screen or the message bar and Setup page.

Table 22: Traffic Messages

Message
Traffic Sensor is Not Communicating
Traffic Sensor is in Stand-By (TAS/TIS)
Traffic Sensor is in Self-Test (TAS)
Traffic Sensor is Operating Normally
TCAD Altitude Unavailable (TCAD)
Traffic Sensor has Failed
After completing all configuration procedures, confirm that the MFD is configured for the
Note:
correct Traffic sensor.
Traffic data is not being received.
The traffic sensor has been placed in Standby mode.
The traffic sensor has been placed in Self-Test mode.
Verification that Traffic data is valid.
Occurs when altitude data has been lost from the TCAD sensor.
The traffic sensor has reported an internal fault, or the RS-232 ports are
not configured correctly (TCAD).
- 52 -
EX5000 Installation Manual
P/N 600-00073 Rev 24
Meaning