Tis Setup; Tis Checkout; Figure 15: Tis Selection On Traffic Setup Page - Avidyne Entegra EX5000 MFD Series Installation Manual

EX5000 Installation Manual
P/N 600-00073 Rev 24

5.7.7 TIS Setup

The EX5000 optionally supports the display of traffic information from a Garmin GTX-330 TIS-capable
Mode-S transponder.
This option is available on 530-00148-000, 530-00162-(), 530-00170-(), 530-00180-(), and
Note:
530-00195-() software.
➤
To set up the TIS Traffic Sensor:
1. From the Maintenance Mode Page, select Traffic Setup. The Traffic Setup Page displays:
2. Set the following options:
■
Sensor—TIS-G
■
Port—Select the MFD ARINC 429 port to which the TIS transponder is wired.
3. When you are done, press Save. Press Cancel to exit without saving changes.
4. Changes do not take effect until the MFD has been restarted. From the Maintenance Mode Page,
press Restart System. If needed, see Table 22, "Traffic Messages," on page 52.

5.7.8 TIS Checkout

Use a TIS transponder test set to test the combined installation of GTX-330 and the EX5000. If no test
set is available, conduct operations in an area that supports TIS data and verify that data is received
and traffic is displayed.

Figure 15: TIS selection on Traffic Setup Page

- 51 -