Avidyne Entegra EX5000 MFD Series Installation Manual page 67

EX5000 Installation Manual
P/N 600-00073 Rev 24
Calibrating the AlliedSignal (Bendix/King) 2000 Radar Sensor
This section describes Post-Installation System Configuration and Calibration of the Bendix/King RDR-
2000 Radar System using the EX5000 and replaces specific sections of the Bendix/King Installation
Manual that describe configuration and calibration using the Bendix/King IN-182A Indicator.
➤
To configure and calibrate the system, follow the original Bendix/King Installation Manual substituting
the following two sections with the instructions provided herein:
● 2.4.1 CONFIGURATION PROCEDURE USING RADAR INDICATOR
●
2.4.4.1 Stabilization Calibration with Radar Indicator
If the EX5000 is replacing the indicator of currently installed and previously calibrated RDR
Note:
2000 Series Radar, this procedure may not be necessary. The calibration values are
contained in the configuration module of the R/T and should remain valid. Avidyne
recommends that you check the calibration values after the Avidyne unit has been installed to
ensure that nothing has changed.
- 57 -