Dual Gps Setup With Gama 429; Figure 8: Gps Setup, Gama 429 - Avidyne Entegra EX5000 MFD Series Installation Manual

2. Configure the following:
■ Receiver—Select GAMA 429 Graphics Format.
■
Port— Select ARINC1.
Selecting Port=None indicates that a GPS is not connected to the MFD. In this case, the MFD
Note:
software does not expect GPS input.
■
Speed—There are two speeds available, High and Low. See Table 16, "GPS/FMS
Manufacturer's Matrix," on page 39 to determine the correct speed for your system.
3. When you are done, press Save to save your changes. Press Cancel to exit without saving
changes.
4. Changes do not take effect until the MFD has been restarted. From the Maintenance Mode Page,
press Restart System.

5.5.2 Dual GPS Setup with GAMA 429

The EX5000 can receive information from two GAMA 429 Graphics capable GPS units. Connect the
GPS according to the wiring diagram in Appendix J: Wiring Diagram – GPS/FMS, using a different
ARINC port for GPS2. Follow the setup instructions in Section 5.5.1.

Figure 8: GPS Setup, GAMA 429

- 36 -
EX5000 Installation Manual
P/N 600-00073 Rev 24