Gps/Fms Installation-Specific Issues - Avidyne Entegra EX5000 MFD Series Installation Manual

Table 16: GPS/FMS Manufacturer's Matrix (Continued)
GPS/FMS RS232 RS-232
Format
Universal No
UNS-1B
Honeywell No
GNS-XLS
Morrow Yes King/
Apollo GX-50 Aviation
* Installations of EX5000 MFDs with Garmin 400 and 500 series GPS units under this installation
manual must be done using ARINC 429. Existing installions may continue to use RS-232 with the
King/Aviation format. See Section 2.4 for more information.

5.5.7 GPS/FMS Installation-Specific Issues

●
Garmin Installation—Some Garmin units provide two RS-232 formats for GPS data. One is an
"aviation" format. The other is an RS232 "plotting" format. The "aviation" format provides a "King"
format 9600 baud output at a higher repetition rate and is the preferred RS-232 output. Consult the
specific Garmin GPS installation manual for full details.
● Northstar Installations—Many Northstar units have a hidden setup screen to change
configuration parameters to make it difficult to change in flight. See the Northstar installation
manual for the specific codes to enter to set this up correctly.
●
Trimble 2000A Installations—This unit has a hidden setup screen documented in the installation
manual to change configuration parameters to make it difficult to change in flight. See the Trimble
Installation manual for the specific codes to enter.
!
Trimble units have been observed to sometimes lose configuration when the aircraft
battery is discharged
ARINC Baud/Data
429 Rate
s
Yes ARINC – High Yes
Yes ARINC – High
or Low
No 9600
- 40 -
Heading GPS/FMS
Output Configuration Notes
—
Yes For GNS-XLS
Configuration
Programming set as
follows: GAMA ARINC 329
Bus Data Set= 1. Basic
EFIS DME Arc Style=1.
Arc as Gap
No Use the Moving Map
format.
EX5000 Installation Manual
P/N 600-00073 Rev 24
DME ARC
—
The arc is
depicted as a gap
—