Appendix K: Wiring Diagram - Lightning, Datalink Sensors, And Orbcomm Antenna - Avidyne Entegra EX5000 MFD Series Installation Manual

Appendix K: Wiring Diagram – Lightning, Datalink Sensors, and ORBCOMM
Antenna
BROADCAST
HEADS UP
DATALINK
XMD076
J1
232 RX
4
GND 23
232 TX 22
IRIDIUM
Avidyne
DATALINK
MLX770
P1 – COM 2
232 RX
6
GND 26
232 TX 5
LIGHTNING
SENSOR
L-3
WX500
P3
232 TX 20
P2
GND
5
P3
232 RX 8
ORBCOMM DATALINK
ANTENNA
NOTES:
1. PORT ASSIGNMENTS SHOWN ARE FOR EXAMPLE ONLY. SELECT PORTS IN MFD MAINTENANCE MODE SETUP PAGES TO
MATCH AIRCRAFT WIRING.
2. ALL WIRE SHALL BE MIL-W-22759/16 (NON-SHIELDED) OR MIL-C-27500 (SHIELDED) OR EQUIVALENT UNLESS OTHERWISE NOTED.
3. ALL WIRE SHALL BE MINIMUM 24 AWG MIN UNLESS OTHERWISE NOTED.
4. TERMINATE SHIELDS TO THE CONNECTOR BACK SHELL OR CHASSIS GROUND AS CLOSE TO CONNECTOR AS POSSIBLE.
5. FOR ADDITIONAL ROUTING, BONDING, AND GROUNDING GUIDANCE REFER TO AC 43-13-1B, CHAPTER 11, SECTIONS 9, 10, 11, AND 15.
6. REFER TO EACH SENSOR'S INSTALLATION INSTRUCTIONS FOR SPECIFIC CONNECTION REQUIREMENTS.
7. SOME SENSOR INTERFACES ARE NOT AVAILABLE ON ALL SOFTWARE PART NUMBERS.
8. MFD RS-232 PORTS 3 AND 4 ARE ONLY AVAILABLE WITH S/N >1200.
10. J1, THE ORBCOMM DATALINK COAX CONNECTOR, IS NOT
AVAILABLE ON P/N 700-00004-001, -002, -007, -009, -010
11. TO MINIMIZE POSSIBLE INTERFERENCE, THE ORBCOMM DATALINK
ANTENNA CABLE SHOULD BE ROUTED AS TO AVOID CLOSE PROXIMITY
WITH OTHER SENSITIVE AVIONICS SYSTEMS. ADDITIONAL CABLE
SHIELDING MAY REDUCE ANY DETECTED SYSTEM INTERFERENCE.
12. ANY AVAILABLE RS-232 PORT MAY BE USED.
Avidyne
MLB700
P1
3
24
2
Avidyne
MLX770
12
P1 – COM 1
3
24
2
Avidyne
TWX-670
J1
20
19
18
11
RG 400 COAX
- 106 -
EX5000 Installation Manual
P/N 600-00073 Rev 24
AVIDYNE
EX5000 MFD
12
P1
69 RS232 TX 4
71 RS232 RTN 4
70 RS232 RX 4
4
12
P1
30 RS232 TX 2
32 RS232 RTN 2
31 RS232 RX 2
4
12
P1
50 RS232 RX 3
51 RS232 RTN 3
49 RS232 TX 3
4
J1
10
1 DL ANTENNA
2 GROUND
AVIDYNE CORPORATION
EX5000 INSTALLATION WIRING:
LIGHTNING, DATALINK SENSORS, AND
ORBCOMM ANTENNA