Mfd Feature Setup And Checkout; Preliminary Test - Avidyne Entegra EX5000 MFD Series Installation Manual

EX5000 Installation Manual
P/N 600-00073 Rev 24

5 MFD Feature Setup and Checkout

This section contains the following information:
●
Section 5.1, "Preliminary Test" on page 29.
●
Section 5.2, "Optional MFD Function Activation Utilities" on page 31
●
Section 5.4, "Using the Maintenance Mode Page" on page 33
●
Section 5.5, "GPS/FMS Navigators Setup" on page 35
●
Section 5.6, "Lightning Sensor Setup" on page 41
●
Section 5.7, "Traffic Sensor Setup" on page 46
●
Section 5.8, "TAWS Setup (Optional)" on page 53
●
Section 5.9, "Radar Sensor (700-00030-005/-805 only)" on page 55
●
Section 5.10, "Engine Instruments Setup" on page 67
●
Section 5.11, "Aircraft Setup" on page 73
● Section 5.12, "Map Setup" on page 79

5.1 Preliminary Test

➤
Power up the MFD for post installation evaluation and configuration. To do so:
1. Turn on the MFD by applying power to the aircraft electrical bus supplying the MFD.
Read the appropriate Pilot's Guide for explanations of various functions.
Note:
2. The green LED control lights behind all the front panel controls should light up.
3. After the initial power up, the software will load and go through several checks. During this startup
sequence the screen displays the text "Initializing-Please Wait...".
4. The startup sequence is finished when the "Press any bezel key to Continue..." message displays.
- 29 -