The fasteners require a panel thickness of 0.080" for proper engagement. Hole patterns and
placements are illustrated in the corresponding appendices.
!
Do not exceed the recommended panel thickness, or the MFD may not fully seat. If
communication between the MFD and any of the sensor interfaces is not established,
ensure that the MFD is fully seated, and then check all sensor connections.
➥
A low resistance (0.5 Ohm) ground path must be established between the MFD chassis and
airframe ground.
- 20 -
EX5000 Installation Manual
P/N 600-00073 Rev 24