Radar Sensor (700-00030-005/-805 Only); Figure 17: Art-2000 Radar Setup Page; Section 5.9, "Radar Sensor (700-00030-005/-805 Only) - Avidyne Entegra EX5000 MFD Series Installation Manual

EX5000 Installation Manual
P/N 600-00073 Rev 24

5.9 Radar Sensor (700-00030-005/-805 only)

Radar support is provided by the Bendix/King RDR-2000 Radar system, including the AlliedSignal
ART-2000 sensor, and is an option available only on the 700-00030-005/-805 EX5000. Radar is
supported only by software part numbers 530-00170-000/001, 530-00180-000/001/, 530-00195-000//
001/010/400/410/510, and 530-00201-000/500.
➤
To set up radar support:
1. From the Maintenance Mode Page, select Radar Setup. The Radar Setup Page displays:
2. From the Radar Setup Page, select the radar sensor installed on this aircraft.
3. Press Save to return to the Maintenance Mode Page
4. From the Maintenance Mode Page, press Restart System.
5. Re-enter Maintenance Mode and select the Radar Setup Page again.
6. Select the following options to finish the installation:
■ ARINC 429 Port—ARINC 429 Tx1
■
ARINC 453 Port—ARINC 453 1
7. When you are done, press Save. Press Cancel to exit without saving changes.
8. Changes do not take effect until the MFD has been restarted. From the Maintenance Mode Page,
press Restart System.
Table 24 describes the configuration options offered by the ART-2000 sensor. For more information,
see the Bendix-King Radar Installation and Operations Manual.

Figure 17: ART-2000 Radar Setup Page

- 55 -