Adjusting the Angle of the Center Mount Footrest
After adjusting the Center Mount Footrest, minimum ground clearance for the
footrest in the driving position is three inches. If the Center Mount Footrest is in the
retracted position and the wheelchair is not moving, the footrest must maintain a
minimum of one inch ground clearance. Otherwise personal injury and damage may
result.
NOTE: For this procedure, refer to FIGURE 11.2 and FIGURE 11.3.
1. Engage the release lever with one hand (FIGURE 11.2) and move the center mount
footrest to the desired angle with the other hand (FIGURE 11.3).
2. Disengage the release lever to lock the center mount footrest in the new position.
FIGURE 11.3 Adjusting the Angle of the Center Mount Footrest
Adjusting the Center Mount Footplate Angle
After 2/14/07
NOTE: For this procedure, refer to FIGURE 11.4.
1. Loosen, but DO NOT remove, the two
rear mounting screws and side mounting
screw.
2. Move the footplate to the desired angle.
3. Tighten the two rear mounting screws
and side mounting screw to secure the
footplate in the desired position.
4. Repeat STEPS 1 and 2 for the other
footplate.
Part No 1114842
SECTION 11—CENTER MOUNT FOOTRESTS
WARNING
Footplate
Center
Mount
Footrest
Rear Mounting
Screws
Side Mounting
Screw
FIGURE 11.4 Adjusting the Center Mount
Footplate Angle - After 2/14/07
121
Center Mount
Front Rigging
Footplate
2G Tarsys®Powered Seating System