Adjusting The Angle Of The Center Mount Footrest; Adjusting The Footplate Angle - Invacare Pronto M71 Owner's Operator And Maintenance Manual

SECTION 16—FRONT RIGGINGS

Adjusting the Angle of the Center Mount Footrest

NOTE: For this procedure, refer to FIGURE 16.8 and FIGURE 16.9.
After adjusting the Center Mount Footrest, minimum ground clearance for the
footrest in the driving position is 3 inches. If the Center Mount Footrest is in the
retracted position and the wheelchair is not moving, the footrest must maintain a
minimum of 1 inch ground clearance - otherwise personal injury and damage may
result.
1. Engage the release lever with one hand
(not shown) and move the center mount
footrest to the desired angle with the
other hand.
NOTE: Refer to FIGURE 16.8 for the location
of the release lever.
2. Disengage the release lever (not shown)
to lock the center mount footrest in the
new position.

Adjusting the Footplate Angle

NOTE: For this procedure, refer to FIGURE 16.10.
1. Loosen the footplate mounting screw
and move the footplate to the desired
angle.
NOTE: DO NOT remove the footplate
mounting screw.
2. Tighten the footplate mounting screw to
secure the footplate in the desired
position.
3. Repeat STEPS 1 and 2 for the other
footplate.
® ™
Pronto M71 with SureStep
WARNING
™ 76
Center
Mount
Footrest
FIGURE 16.9 Adjusting the Angle of the
Center Mount Footrest
Footplate
Mounting
Screw
FIGURE 16.10 Adjusting the Footplate
Angle
Footplate
Center Mount
Footrest
Footplate
Part No 1141449