Adjusting The Angle Of The Manual Center Mount Footrest; Adjusting The Footplate Angle - Invacare Formula Owner's Operator And Maintenance Manual

SECTION 6—FRONT RIGGINGS
Adjusting the Angle of the Manual Center Mount
Footrest
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
NOTE: For this procedure, refer to FIGURE 6.17 and FIGURE 6.18.
1. Engage the release lever with one hand
(not shown) and move the center
mount footrest to the desired angle
with the other hand.
NOTE: Refer to FIGURE 6.16 for the location
of the release lever.
2. Disengage the release lever (not
shown) to lock the center mount
footrest in the new position.

Adjusting the Footplate Angle

NOTE: For this procedure, refer to FIGURE 6.19.
1. Flip footplate up.
2. Screw the adjustment screw in or out until the desired angle is achieved.
3. Repeat STEPS 1 and 2 for the other footplate.
Formula™CG Powered Seating
WARNING
Manual Center
Mount Footrest
(shown away from Extension Tube)
Adjustment
Screw
FIGURE 6.19 Adjusting the Footplate Angle
Center Mount
Footrest
FIGURE 6.18 Adjusting the Angle of the
Manual Center Mount Footrest
Footplate
54
Footplate
Part No 1143155