Electrically Connecting The Sections; Figure 4-7. Isbm Section To Upm Section Joining Brackets - Eaton Power Xpert 9395P-900 Series Installation And Operation Manual

Screw from Kit
Bracket from Kit
ISBM
Section Top
Top View Front Bracket

Figure 4-7. ISBM Section to UPM Section Joining Brackets

4.4

Electrically Connecting the Sections

1. Unfasten the front door latch and swing the door open (see Figure 4-1).
2. Remove the door. Remove the retaining screw located inside the door at the bottom hinge pivot point,
then lift the door off. Retain the hardware for later use.
3. Remove the screws securing the ISBM section right bottom internal safety shield panel and remove the
panel to gain access to the internal input, output, and battery terminals. Retain the hardware for later use.
4. Locate the AC and DC input intercabinet power wiring harnesses (long cables labeled xG1, xG2, and xG3).
Remove wire ties as necessary and uncoil the cables.
Eaton
Screw from Kit
Section Top
Front
Bracket from Kit
ISBM Section Base
Screw from Kit
NOTE AC and DC input intercabinet power wiring harnesses are supplied coiled and
secured in the UPM wireway on the left side of the UPM section (see Figure 4-6).
® ®
Power Xpert 9395P-900 UPS Installation and Operation Manual P-164000501—Rev 09
Screw from Kit
UPM
Bracket from Kit
ISBM
Section Top
Front View Base Bracket
Screw from Kit
UPS System Installation
Screw from Kit
Back
Top View Rear Bracket
UPM Section Base
www.eaton.com/powerquality
UPM
Section Top
4-9