Control Interface Module In The Active Line Module Chassis Format - Siemens SINAMICS S120 Commissioning Manual

State
Ready DC link
Red
Orange Orange
Red –
Green / red –
flashing light
0.5 Hz
Green / red –
flashing light
2 Hz
Green / –
orange
or
Red / orange
5.2.2.7

Control Interface Module in the Active Line Module chassis format

Table 5- 10 Meaning of the LEDs "READY" and "DC LINK" on the Control Interface Module in the Active Line Module
LED, state
Ready DC link
Off Off
Green Off
Orange
Red
Orange Orange
Red ---
Green / red ---
flashing light
0.5 Hz
Commissioning with Startdrive
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0
Description, cause
The component is ready for operation and cyclic DRIVE-
CLiQ communication is taking place.
The DC link voltage is too high.
DRIVE-CLiQ communication is being established.
At least one fault is present in this component.
Note:
LED is controlled irrespective of the corresponding messag-
es being reconfigured.
Firmware is being downloaded.
Firmware download is complete. Wait for POWER ON.
Component detection via LED is activated (p0124).
Note:
Both options depend on the LED status when module
recognition is activated via p0124 = 1.
Description
The electronic power supply is missing or lies outside the permissible tolerance range.
The component is ready for operation and cyclic DRIVE-CLiQ communication is taking
place.
The component is ready for operation and cyclic DRIVE-CLiQ communication is taking
place.
The DC link voltage is present.
The component is ready for operation and cyclic DRIVE-CLiQ communication is taking
place.
The DC link voltage is too high.
DRIVE-CLiQ communication is being established.
At least one fault is present in this component.
Note:
LED is activated irrespective of any reconfiguring of the corresponding messages.
Firmware is being downloaded.
Diagnostics
5.2 Diagnostics using LEDs
Remedy
Check the line voltage
–
Remedy and acknowledge
fault
–
Carry out a POWER ON
–
247