Siemens SINAMICS S120 Commissioning Manual page 65

Connecting a signal
To make a connection, proceed as follows:
1. Click the binector or connector icon of the signal that you want to connect (
A connection dialog for the selection of the possible parameters opens. The drive object
for which you want to make a connection is displayed automatically in the "Drive object"
drop-down list on the right.
Figure 3-2
The last set signal source is displayed in the "Selected source" field. If a connection was
not available previously, the value 0 is displayed.
2. Select the parameter that you want to connect.
If connectable bits of the parameter are available, they are displayed in a drop-down list.
Commissioning with Startdrive
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0
BICO interconnection dialog
Fundamentals
3.3 BICO interconnections
or ).
63