Terminal Modules; Terminal Module Tm15 - Siemens SINAMICS S120 Commissioning Manual

LED Color
Green/red Flashing
Green/
orange
or
Red/
orange
5.2.4

Terminal Modules

5.2.4.1

Terminal Module TM15

Table 5- 28 Meanings of the LEDs on the Terminal Module TM15
LED Color
READY -
Green
Orange
Red
Green/re
d
Green/or
ange
or
Red/oran
ge
The parameters for activating component recognition using LEDs can be taken from the following reference:
1)
Reference: SINAMICS S120/S150 List Manual
Commissioning with Startdrive
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0
Status Description, cause
Firmware is being downloaded.
light 0.5
Hz
Flashing Firmware download is complete. The system waits for
light 2 Hz POWER ON.
Flashing Detection of the component via LED is activated (p0144 =
light 1).
Note:
Both options depend on the LED status when component
recognition is activated.
Status
Off The electronics power supply is missing or outside the per-
missible tolerance range.
Continuous The component is ready for operation. Cyclic DRIVE-CLiQ
light communication is taking place.
Continuous DRIVE-CLiQ communication is being established.
light
Continuous This component has at least one fault.
light
Note:
The LED is activated irrespective of whether the correspond-
ing messages have been reconfigured.
Flashing Firmware is being downloaded.
light 0.5 Hz
Flashing Firmware download is complete. The system waits for
light 2 Hz POWER ON.
Flashing Component recognition via LED is activated
light
Note:
Both options depend on the LED status when component
recognition is activated.
Description, cause
.
1)
Diagnostics
5.2 Diagnostics using LEDs
Remedy
–
Carry out a POWER
ON.
–
Remedy
–
–
–
Correct and
acknowledge the
fault.
–
Carry out a POWER
ON.
–
257