Siemens SINAMICS S120 Commissioning Manual page 109

The procedure for detail settings is identical for Motor Modules and Power Modules.
Procedure
Detailed settings are shown below, using a Power Module as an example.
1. Select the desired Power Module in the device view and open the Inspector window.
2. Select the menu "Power Module Details > Power Module Settings" in the Inspector
window.
The preallocated supply voltage is displayed in the screen forms:
Figure 4-23
3. Enter a new supply voltage as required.
4. If you use the "VECTOR" drive object type, you can set additional data.
Select the menu "Power Module Details > Power Module Additional Data" in the Inspector
window.
Commissioning with Startdrive
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0
Example: Power Module Settings
4.4 Creating a project offline in Startdrive
Commissioning
107