Siemens SINAMICS S120 Commissioning Manual page 155

4.7 Alternatively: Creating a project with a device configuration derived from the hardware
Creating the component topology in Startdrive
After you have checked and, if required, corrected the topology determined in the
configuration, you can transfer this topology to a Startdrive project.
1. Make sure that there are no non-assignable components in the "Device configuration
detection" dialog.
Only when there are no non-assignable components is the "Create" button active.
2. Click the "Create" button.
Result
The topology is created in the device configuration of the selected drive unit.
Figure 4-56
Commissioning with Startdrive
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0
Example: Apply hardware device configuration to Startdrive configuration
Commissioning
153