Adding A Terminal Module; Adding The Vsm10 Voltage Sensing Module - Siemens SINAMICS S120 Commissioning Manual

4.4.9.3

Adding a Terminal Module

With Terminal Modules, you can expand the interfaces of the Control Unit. They are
connected to the Control Unit via DRIVE-CLiQ. Terminal Modules do not have to be
specified any further.
Preconditions
● A project has been created.
● A Control Unit is contained in the device configuration.
Procedure
1. Open "Additional system components > Terminal Modules" in the hardware catalog.
The following Terminal Modules can be selected:
– Terminal Module TM15
– Terminal Module TM31
– Terminal Module TM41
– TM120 Terminal Module
– TM150 Terminal Module
2. Select the Terminal Module in the device overview.
3. Drag the Terminal Module to the device view.
The DRIVE-CLiQ connections are drawn automatically.
4.4.9.4

Adding the VSM10 Voltage Sensing Module

Voltage Sensing Modules (VSM) can be used for 2 different drive objects:
● Infeed unit
Is used for voltage measurement, e.g. for the "mains transformer" function.
A VSM10 allows an exact recording of the line voltage curve and supports the fault-free
operation of the Line Modules in unfavorable network conditions.
● Motor Modules of the VECTOR type
Required for the functions "synchronize" and "flying restart".
Note
Voltage Sensing Modules are inserted automatically with Active Line Modules or Smart Line
Modules in Chassis design.
Commissioning with Startdrive
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0
4.4 Creating a project offline in Startdrive
Commissioning
125