Siemens SINAMICS S120 Commissioning Manual page 150

Commissioning
4.7 Alternatively: Creating a project with a device configuration derived from the hardware
3. Select the desired S120 drive unit in the list.
Figure 4-53
Note
Comparing and possibly changing version numbers
When creating a drive device, the current firmware version is always suggested. It is
possible that the suggested firmware version does not match the version number of your
memory card in the drive device. If the version numbers do not match, it will not be
possible to subsequently go ONLINE. Therefore, please observe the following notes:
• Observe the version number displayed in the drop-down list "Version" (to the right in
• When required, change the version number using the "Version" drop-down list.
4. When required, enter a different device name in the input field at the top left, and then
click "OK".
148
Dialog: Adding a new drive unit
the dialog), and ensure that the displayed version number matches the version
number of your memory card at the drive device.
Commissioning with Startdrive
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0