Drawer Paper Lifting/Lowering Mechanism/Control - Minolta EP5000 General, Mechanical/Electrical

Interleaf EP5000/EP4000 GENERAL, MECHANICAL/ELECTRICAL
97.04.01
1156SBM1802A

18-2. Drawer Paper Lifting/Lowering Mechanism/Control

(1) Metric Areas
D The paper lifting mechanism raises the paper in the drawer so that the top of the
paper stack is pressed against the Paper Take-Up Roll at a constant pressure.
D When slid into the copier, the drawer presses the Drawer Set Lever which engages
Lift-Up Motor Gear 1 with Paper Lifting Arm Gear 2.
D At the same time, the Drawer Set Sensor (PC61 /PC62) is blocked (goes LOW) and
after 1 msec., the Lift-Up Motor (M13/M14) starts turning, causing the Paper Lifting
Arm to raise the Paper Lifting Plate.
D When the drawer is slid out, Lift-Up Motor Gear 1 is disengaged from Paper Lifting
Arm Gear 2, lowering the Paper Lifting Plate.
Rear
Paper Lifting Arm
When Drawer is Slid in
1st/2nd Drawer Lift -Up
Sensor (PC65/66)
4425M005AA
Gear 2
Gear 1
D The Paper Lifting Arm further raises the paper
after the top sheet of paper is pressed against
the Paper Take-Up Roll. As the light blocking
plate blocks the Lift-Up Sensor (goes LOW), the
Lift-Up Motor (M13/M14) stops.
M-60
1st/2nd Drawer
Lift-Up Motor
M13/14
Front
4425M004AA