17-2. Drawer Positioning
Each of the 1st and 2nd Drawers is positioned by fitting its Positioning Plate
on the paper take-up end into the groove in the Drawer Frame. It is then
secured in position by the magnet installed in the Drawer Front Cover on the
paper take-up end. The tabs on both sides at the front of the Drawer ensure
that the Drawer clicks into position. Any deviation in the paper path
reference position can be adjusted within ±2 mm by moving the Front Cover
of the Drawer to the front or rear.
Tab
17-3. Paper Lifting Plate
The Paper Lifting Plate of each Drawer is raised at all times by two Paper
Lifting Springs.
For the 2nd Drawer, the type and position of the Paper Lifting Springs must
be changed according to the paper size. (For details, see
DIS/REASSEMBLY, ADJUSTMENT.)
Rear End
Front End
Tab
Paper Lifting Plate
Paper Lifting Springs
M-58
Positioning
Plate
Positioning
Plate