Minolta EP5000 General, Mechanical/Electrical page 245

Interleaf EP5000/EP4000 SWITCHES ON PWBs, TECH. REP. SETTINGS
97.04.01
Tech. Rep. Mode " Tech. Rep. Choice
Touch Panel Display
Maintenance Call
Copy Kit Counter
Toner Empty Stop
Type of Vendor
Auto Paper Config.
Select whether to enable or disable the maintenance call reminder mes-
sage that is displayed when the maintenance counter count reaches the
preset value.
NO
NOTE: Up to five maintenance counters may be set and the maintenance
call reminder message is given when the count of any one of
these five counters reaches the preset value, together with the
display of maintenance code "M1."
Select whether to enable or disable the "Copy Kit" counter; if the counter is
to be enabled, select whether to allow or inhibit the start of a copy cycle
when the count reaches the preset value.
NO Disables the Copy Kit counter.
Copying not inhibited after the count reaches
Mode 1
the preset value.
Copying inhibited after the count reaches the
Mode 2
preset value.
NOTE: The Copy Kit counter is enabled by selecting mode 1 or 2. When
the count reaches the preset value, the maintenance code "M4" is
displayed.
Select whether or not to inhibit copying when a toner-empty condition is
detected.
Enable Copy
NOTE: When "Disable Copy" is selected, copying is inhibited when a T/C
of 2.5% or less is detected.
Make the display setting according to the type of optional vendor mounted
on the copier. (Japan only)
Key Counter Disables the Copy Kit counter.
Coin Vendor
Card Vendor
NOTE: Select "Key Counter." No other setting should be made.
Select either "Inch/Metric" or "Metric" for rounding off the original size
detected.
Inch/Metric
Metric
S-21
Operation
YES
Disable Copy
The measurement is rounded to the
nearest standard inch or metric
size.
The measurement is rounded to the
nearest standard metric size.