Minolta EP5000 General, Mechanical/Electrical page 142

Interleaf EP5000/EP4000 DIS/REASSEMBLY, ADJUSTMENT
97.04.01
1156D032AA
1136D101AA
1134D028AA
(11) Disassembly of the Suction Unit
1136D103AA
9. Swing down the Transport Section Release Lever.
10. Holding up the Suction Unit, remove the compression coil.
11. Remove the Suction Unit by sliding it to the right.
NOTE
When removing and reinstalling the Suction Unit, use care
not to bend the ground plate located on the right in the rear.
NOTE
When reinstalling the Suction Unit, make sure that two
positioning pins on the copier fit into the positioning holes
in the Suction Unit.
1. Remove the Suction Unit.
2. Remove two screws and the duct.
3. Remove four screws and the Suction Drive Unit.
NOTE
When reinstalling the Suction Drive Unit, try to press it
down against the Suction Base Plate.
1136D102AA
4. Remove three driven rolls.
D-23