Minolta EP5000 General, Mechanical/Electrical page 260

Interleaf EP5000/EP4000 SWITCHES ON PWBs, TECH. REP. SETTINGS
97.04.01
Touch Panel
Display
RD Mode
Maintenance
Data Save/Load
Data Save
Data Load
Initial Transmission
Call Completion
Counter Clear
Tech. Rep. Mode " RD Mode
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Enables transmission of Data Save and Data Load.
Transmits the command that saves the PPC RAM data to the Center.
Transmits the command that loads the data sent by Data Save back to
the PPC.
Used to perform the initial transmission from the PPC to the Center to
check for correct communication when the Data Terminal has been set
up.
Used by the Tech. Rep. to notify the Center that his/her service job for
the copier has been completed.
Used to clear the count of the spare counter set by the Center.
<Procedure>
1. Select the spare counter to be cleared.
2. Touch "Call Completion" which transmits a signal to the Center to clear
the count of the specified counter.
S-36
Setting