Nortel 1120E Administration Manual page 93

Table 31
PC-Port Untag-All Configuration in Device Settings menu
PC-Port Untag all :
17
Table 32
Ethernet port mode configuration
Duplex :
Ignore GARP:
18
Copyright © 2008, Nortel Networks
.
If Data VLAN is enabled in step 15, PC-Port Untag All is enabled
and the check box is checked by default. In this case, the outgoing
tag is stripped. Override the default by pressing the Select key to
remove the checkmark.
If Data VLAN is disabled, PC-Port Untag All is disabled and the
check box is not checked by default. In this case, the ingress tag is
not stripped. The default can be overridden by pressing the Select
key, which places a checkmark in the box.
Configure the Ethernet port mode.
The Ethernet port mode is configured by the items in the Device
Settings menu Duplex and Ignore GARP.
• Duplex: Duplex enables or disables Ethernet speed and mode
negotiation. Select Auto unless the Ethernet port speed must be
set to 10 MB/s or 100 MB/s. Select 10BT Full for 10 MB/s and
100BT Full for 100 MB/s.
• Ignore GARP: GARP requests handling. The default can be
overridden by pressing the Select key, which places a check
mark in the box.
Auto
Auto
10BT Full
100BT Full
Enter Provisioning Parameters: Server URL, Protocol, Device ID,
and Password.
The next four tables show menu items in the Device Settings menu
that apply to configuring the Provisioning parameters.
• Server URL: Enter the URL of the provisioning server in the
Server URL box.
SIP Firmware Release 1.1 for IP Phone 1120E Administration
NN43112-300 02.03 Standard
27 May 2008
Configure the device settings 93