Sntp_Server; Madn_Timer; Madn_Dialog; Default_Cfwd_Notify - Nortel 1120E Administration Manual

•
•
•
•
•
Copyright © 2008, Nortel Networks
.
Create the Device Configuration file on the provisioning server 43
SNTP_ENABLE [YES | NO] allows the IP Phone 1120E to obtain the
time and date from an NTP server. The default is NO.
The IP Phone 1120E updates the time once every 24 hours from the
NTP server. If the IP Phone 1120E cannot contact the server, the IP
Phone 1120E tries every 15 minutes up to a maximum of 6 attempts,
and then hourly attempts are made. If SNTP_ENABLE is set to NO
the IP Phone 1120E tries to retrieve the time and date from the SIP
proxy server. However, not all SIP proxy servers support this method
of retrieving the time and date.
— YES - enables NTP.
— NO - disables NTP.
SNTP_SERVER [ip_address] is the IP address or FQDN of the NTP
server that provides the time and date to the IP Phone 1120E. If this is
not specified, the IP Phone does not generate any NTP requests.
— ip_address - the IP address of the NTP server in either Fully
Qualified Domain Name (FQDN) or non-FQDN format..
MADN_TIMER [x] is used to set the MADN polling timer interval (the
interval at which the IP Phone 1120E attempts to determine the MADN
group of the logged-in user). The minimum value for the polling interval
is 900 seconds (15 minutes). The default value is 1800.
— x - the time delay (in seconds) between queries to find the MADN
group DN of a user. The minimum value 900.
MADN_DIALOG [YES |NO] is used to set the SIP URI or the GROUP
DN for the subscription to the dialog event. The default value is NO.
— YES - subscribes to the dialog event using the SIP URI of the user.
— NO - subscribes to the dialog event using the group of the user.
Note: The SIP URI is used to subscribe for MADN support for CS
2000.
DEFAULT_CFWD_NOTIFY [YES | NO] is used to configure the "ring
splash" which occurs when either local call forwarding (MCS 5100) or
network-based call forwarding have been enabled (CS 2000, CS 2100).
If this configuration value is enabled, the IP Phone 1120E plays an
abbreviated ring tone to remind the user that a call has been forwarded.
This configuration value only effects users when their user profile is
first created, unless the FORCE_CFWD_NOTIFY flag is also used.
The default setting is NO.
— YES - a brief ring splash plays when a call is forwarded.
SIP Firmware Release 1.1 for IP Phone 1120E Administration
NN43112-300 02.03 Standard
27 May 2008