Physically Install The Ip Phone 1120E - Nortel 1120E Administration Manual

Physically install the IP Phone 1120E

Complete instructions to physically install the IP Phone 1120E, including
detailed figures and applicable warnings, are given in the document SIP
Firmware Release 1.1 for IP Phone 1120E User Guide (NN43112-104).
The steps for installing the IP Phone 1120E are summarized in the following
procedure.
Procedure 4
Installing the IP Phone 1120E
Step
1
2
3
4
5
Copyright © 2008, Nortel Networks
.
Action
Remove the stand cover. Pull upward on the center catch and
remove the stand cover. The cable routing tracks are now accessible.
Connect the AC power adapter (optional). Connect the adapter to
the AC adapter jack in the bottom of the IP Phone 1120E. Form a
small bend in the cable, and then thread the adapter cord through
the channels in the stand.
Install the handset. Connect the end of the handset cable with the
short straight section into the handset. Connect the end of the
handset cable with the long straight section to the back of the IP
Phone 1120E, using the RJ-9 handset jack. Form a small bend in
the cable, and then thread the handset cord through the channels in
the stand so that it exits behind the handset on the right side, in the
handset cord exit in the stand base.
Install the headset (optional). If installing a headset, plug the
connector into the RJ-9 headset jack on the back of the IP Phone
1120E, and thread the headset cord along with the handset cord
through the channels in the stand, so that the headset cord exits
the channel.
Install the Ethernet cable. Connect one end of the supplied Ethernet
cable to the back of the IP Phone 1120E using the RJ-45 connector
and thread the network cable through the channel.
SIP Firmware Release 1.1 for IP Phone 1120E Administration
NN43112-300 02.03 Standard
27 May 2008
63