Nortel 1120E Administration Manual page 92

92 Device Settings on the IP Phone 1120E with SIP Firmware
12
13
Table 28
VLAN Filter configuration
VLAN Filter :
14
Table 29
Disable PC Port configuration
Disable PC Port :
15
Table 30
Data VLAN Configuration in Device Settings menu
Data VLAN :
16
Copyright © 2008, Nortel Networks
.
Choose one of the following for Voice VLAN: No, Auto or 4095.
Enable or disable the VLAN Filter. Press the Select key to enable
the VLAN Filter.
A check mark in the VLAN Filter box indicates that the VLAN Filter
is enabled.
Disable PC Port configuration. Press the Select key to turn off the
PC port on the IP Phone 1140E.
A check mark in the Disable PC Port box indicates the PC port is
disabled.
Disable PC Port can be used in an environment where administrators
do not want users accessing the data network through the built-in
PC port.
Configure the Data VLAN.
It is possible to Enable or disable separate VLAN for anything other
than voice and signaling.
No
No
4095
Configure PC-Port Untag-All, which configures PC-Port VLAN Tag
Stripping. Check the check box by pressing the Select key in the
Navigation key cluster to enable this item.
If the check box is not checked, tag stripping is disabled and
the packet is sent to the PC port unmodified. If the check box is
checked, tag stripping is enabled and the 802.1q header is removed
(assuming one exists) from the packet before it is forwarded through
the PC port.
SIP Firmware Release 1.1 for IP Phone 1120E Administration
NN43112-300 02.03 Standard
27 May 2008