Nortel 1120E Administration Manual page 53

$3="."
$4="com"
$5="Nortel.com"
$t=10000 (default timer is 10 seconds)
$a=Nortel.com
The second section of dialing plan contains the digit map. The digit map
section has three subsections that are divided by a separator of two
ampersands (&&).
Figure 9
Sample dialing plan digit map section
The first part of a dialing plan contains a pattern defined with DRegex, which
is used for matching the dialed number. The patterns are separated by the
pipe (|) sign. The second part contains the result string used in the dial step.
The third part defines the parameters used by UA in dialing action.
The following parameter is currently defined:
t=xxxx: After this timer expires, the number entered is automatically dialed.
The timer starts after the first digit is entered and after it expires, the
collected digits are automatically dialed out. xxxx is a decimal number in
msec. The default timer is used when t is not specified in the digit map.
For example:
X{4} && sip:$$; phone-context=nortel.com;user=phone && t=7000
When the user presses any 4 digits, such as 4567, the following SIP URIs
are generated because of the translation rule:
Sip:4567; phone-context=nortel.com;user=phone. The timeout of stopping
the collection of digits is 7 seconds.
Copyright © 2008, Nortel Networks
.
Create the Dialing Plan file on the provisioning server 53
SIP Firmware Release 1.1 for IP Phone 1120E Administration
NN43112-300 02.03 Standard
27 May 2008