Jitter_Warn; Jitter_Exce; Delay_Enable; Delay_Warn - Nortel 1120E Administration Manual

•
•
•
•
•
•
•
System commands
•
Copyright © 2008, Nortel Networks
.
Create the Device Configuration file on the provisioning server 49
JITTER_WARN [xx] is the threshold to report a warning on Inter-arrival
Jitter. The default is 3276 (50ms).
— xx - any integer value that is 1/65536 of a second.
JITTER_EXCE [xx] is the threshold to report unacceptable Inter-arrival
Jitter. The default is 32768 (500ms).
— xx - any integer value that is 1/65536 of a second.
DELAY_ENABLE [YES | NO] is used to enable or disable Excessive
Delay detection. This is the one-way delay (including system delay) for
the call, measured in milliseconds.
— YES - enables Excessive delay detection.
— NO - disables Excessive delay detection.
DELAY_WARN [xx] is the threshold to give warning on Excessive
Delay. The default is 150ms.
— xx - any integer value that is 1/65536 of a second.
DELAY_EXCE [xx] is the threshold to report unacceptable Excessive
Delay. The default is 175ms.
— xx - any integer value that is 1/65536 of a second.
SESSION_RPT_EN [YES | NO] is used to enable or disable periodic
VQMon session reports. The default is disabled.
— YES - enables periodic VQMon session reports.
— NO - disables periodic VQMon session reports.
SESSION_RPT_INT [xx] is used to specify the interval for the periodic
VQMon session report in seconds. The default is 60 seconds.
— xx - the value in seconds.
ADMIN_PASSWORD [password] is used to change the default
administrator password of the IP Phone 1120E that is used for unlocking
network menus. The default is 26567*738.
— password - the administrator password.
SIP Firmware Release 1.1 for IP Phone 1120E Administration
NN43112-300 02.03 Standard
27 May 2008