Nortel 1120E Administration Manual page 74

74 Upgrade and convert the IP Phone 1120E firmware
Procedure 10
Downloading UNIStim Firmware automatically through TFTP on bootup
Step
1
2
3
4
5
6
Copyright © 2008, Nortel Networks
.
Action
Press the Globe/Services key on the IP Phone 1120E twice quickly.
If the admin password prompt appears, enter the password
26567*738
The Local Tools menu appears:
Table 13
Local Tools menu
1. Preferences
2. Local Diagnostics
3. Device Settings
4. Lock Menu
Select 3. Device Settings from the Local Tools menu.
The Device Settings screen appears.
If you are using DHCP, select Full or Partial. If you are manually
configuring the IP address, netmask, and gateway address, select
No.
If the DHCP option is set to Full or Partial, the IP address is
automatically obtained.
Configure the TFTP IP address within the IP Phone 1120E Device
Settings menu.
This can be the provisioning server as defined in the chapter
"Configure the provisioning server" (page
Select the Apply&Reset Context-sensitive soft key to save the
settings and reset the IP Phone 1120E.
The IP Phone 1120E downloads the firmware file. The display
shows [FW] reading...
If the download is successful, the display shows [FW] writing...
and the blue LED flashes.
After the firmware image is downloaded to the IP Phone 1120E, the
display shows [FW] finished... the blue LED stops flashing, and the
IP Phone 1120E resets.
If the upgrade is unsuccessful, see the chapter
troubleshooting" (page 123)
SIP Firmware Release 1.1 for IP Phone 1120E Administration
NN43112-300 02.03 Standard
in the section Download failures.
27 May 2008
25).
"Maintenance and